Slag remover,MFS slag remover is a positive slag remover which removes impurities in pulp by centrifugal principle.
A detachable structure: slag remover is a detachable device that can be divided into three main parts: the remover body (Figure 1), the lower ceramic cone (Figure 2), and the Ceramic slag discharge nozzle (Figure 3). These parts are connected with inlet and outlet main pipe through valve (Figure 4) for disassembling and replacement.
B. A higher separation efficiency is assured with a maximum operating concentration rate reaching 1.2%. Through the dilution of the the tailings pipe, it will not be blocked in the operation process and reduce the loss of fiber and improve the ability.
C. Whose inner wall is polished. Thus there will be no pulp left on the inner wall. And no fibrous deposition is produced during the stroke.
Single pass quantity:1800L/min
Inlet pulp concentration: 0.5-1.2%
Feed pressure: 0.20-0.35MPa
Pressure difference of pulp inlet and outlet:0.1-0.15 MPa
pulp inlet caliber:DN100
caliber of filtered pulp outlet:DN100
Volume discharge rate:20-40%
Maximum pulp inlet temperature:85℃
Purification rate: the removal rate of fine gravel:≥85%